Power a downconverter from a receiver

Downconverters connected directly by coaxial cable to a receiver require power via the receiver’s UHF connector.

To use this option, you must enable BNC power to the appropriate UHF connectors via the receiver’s Receive configuration settings.

The BNC output power supply is dependent upon the receiver power supply and has the following characteristics.

Table 1. BNC output voltages and BNC current limits

Receiver supply	BNC output voltage	BNC current limit
AC	24 V DC	2 A (each port) / 8 A (total)
DC (10 to 36 V DC)	Follows input supply	2 A (each port) / 4 A (total)