Mounting procedure for two receivers

To mount two receivers side by side, you will require 2RU (3.5 inches, 89 mm) of vertical rack space and a Real Freedom Dual Receiver Rack Mount Kit (BRK-0006-00).

Figure 1. Joining two receivers for rack mounting. 1 Bracket Fixing 2U, 2 Joining Blocks, 3 Bracket Fixing 2U, 4 Block Joining Rear.


  1. Attach a Bracket Fixing 2U to the left-hand side of one receiver and to the right-hand side of the other receiver using four M5 x 12 Phillips screws.
  2. Attach a Joining Block the other side of each receiver using two M5 x 25 Philips screws.

    You should attach the Joining Block in the ‘top’ position on one receiver and in the ‘bottom’ position on the other receiver.

  3. Attach a Block Joining Rear Tapped to one receiver and a Block Joining Rear CSK to the other receiver using two M3 x 12 Philips screws.

    You should attach these blocks on the same sides of the receivers as the joining blocks.

  4. Position the receivers together and secure the front and rear joining blocks.

    Connect the front joining blocks using two M5 x 60 Phillips screws (one inserted through the top block, and the other inserted through the bottom block).

    Connect the two rear joining blocks using an M5 x 25 Philips screw.
  5. Install the two receivers at the desired location in the equipment rack and secure to the vertical uprights using four rack screws.