Rack mount a UHF splitter

The Real Freedom Active UHF Splitter is designed to be mounted in a standard 19-inch (48.3 cm) equipment rack. The unit is 1RU high and half rack width. A rack mount kit (20006-9-005) allows you to mount two UHF splitters side by side.
Note: You can also place a UHF splitter on a solid, stable surface.

Tools

To rack mount a Real Freedom Active UHF Splitter, you will require the following tools:

  • #3 Phillips head screwdriver

Precautions

You should read these precautions before you install a Real Freedom Active UHF Splitter in an equipment rack.

  • Active UHF splitters are fragile and vulnerable to damage. If you drop or damage the unit, it should be returned to BSI for inspection.
  • Before you begin the installation, make sure that the splitter is disconnected from the power source.
  • Close any open spaces in the rack with blank panels since open spaces will reduce cooling efficiency.
  • To prevent the risk of overheating, use in a well-ventilated area.
  • Since there is no power button (on/off switch) on the UHF splitter, ensure that you have access to the rear of the rack or leave a sufficient wire management loop to pull the unit out from the front of the rack.

Mounting procedure for a UHF splitter

To mount the UHF splitter, you will require 1RU (1 ¾ inches, 44.45 mm) of vertical rack space and a Real Freedom UHF Splitter Rack Mount Kit (20006-9-005).

  1. Attach the Rack Mount Plate to each UHF splitter using four M3 x 8 screws.

  2. Install the UHF splitter at the desired location in the equipment rack and secure to the vertical uprights using four rack screws.