Audio

From the main screen, tap Audio and configure as follows.

Table 1. Audio configuration
Setting Description
Stream A / Stream B

Sets the audio sources for Stream A and Stream B.

Note that you can enable both Stream A and B at the same time and can use the same or different sources.
Analog 1-2 is the primary analog audio into the camera back transmitter via the XLR-3 AUDIO 1 and AUDIO 2 connectors (or Audio 1 L+R LEMO on the low-profile I/O module).
Analog 3-4 is the secondary/aux analog audio into the camera back transmitter via the AUX connector (or Audio 2 L+R LEMO on the low-profile I/O module).
SDI 1-2/3-4 is channels 1-2/3-4 of embedded audio from microphones plugged into the camera.
Ch1 / Ch 2 Sets the strength of the audio signal as either ‘Mic’ or ‘Line’ level.
Phantom

Phantom is used to enable phantom power by channel if required by the microphone.

Note that when you use a stereo microphone that requires phantom power, you must switch on BOTH channels for phantom power (Phantom Ch 1 and Phantom Ch 2).
Ch3 / Ch4 Sets the strength of the audio signal as either ‘Mic’ or ‘Line’ level.