Network
From the main screen, tap Settings and select Network. The Network page displays the current network configuration, including whether the IP address is static or allocated by DHCP.
Tap ‘Next’ to display the Network Config page and configure as follows.
| Setting | Description |
|---|---|
| Use DHCP |
Specifies whether to dynamically assign an IP address and other network configuration parameters to the transmitter. Clear this check box to disable DHCP and set a static IP address. |
| IP | Enter the required IP address to identify the camera back transmitter on the network. This IP address must match the subnet of the Operator Control Panel/ Remote Control Panel (OCP/RCP). |
| Netmask | Enter the required subnet/network mask. This must be the same as the RCP’s subnet mask. |
| Apply changes | Tap to apply any changes. Note that you must reboot the transmitter to activate the new configuration. To do this, remove the power cable, wait a few seconds, and then reconnect the power cable. |